top of page

DRYWALL SCREW

Dry Wall Screw

Drywall Screw is a specialized self-tapping screw with a cylindrical shaft. These screws almost always have a Phillips Bulge Head rather than a slotted head, which provides additional control for installers. In addition of a standard drill, installers also use a tool known as a drywall dimpler, which has an adjustable nose to install a drywall screw without tearing the paper on each sheet.

Gipson Board
Dry1

A standard drywall screw can be readily identified by its black finish. This black coloring comes from a phosphate mineral coating that is applied to these screws. This coating helps to minimize rusting and corrosion as the screws are exposed to wet joint compound or paint.

  • Original and primary application is to stitch Drywall to wood studs. Also used in many interior wood and fixture fastening applications.

  • Used to rapidly attach drywall to metal studs for commercial buildings.

  • Used where flat surface required after drill.

  • Used where already pre-drilled holes are prepared for fitting.

  • The primary benefit offered by drywall screws is their Bugle Head. This means that the entire screw lies flush with the surface of the sheet, creating a smooth and even finish.

  • Less prone to getting pulled through the wood due to Bugle Head.

  • This type of head also helps prevent the drywall screw from breaking the paper surface, a common problem with nails.

  • Drives fast and efficient.

  • The black head adds to the decorative appeal.

  • Fairly thin, so they are less likely to split the wood.

  • Threaded through entire length thereby maximizing gripping power.

  • Good Corrosion resistance due to black phosphate coating.

  • Easy to install and remove.

  • Head does not sink into the wood easily as does with other wood screws.

  • Precise cutting edges to improve drill performance with less effort.

  • Relatively Cheap.

  • At least 3 times the pull-out strength of nails.

bottom of page